Telnet Hacking

1. Get an IP scanner, or get the IP in which you want to connect to. 

2. If you got the IP from other sources besides an IP scanner, then type "Ping 0.0.0.0" (in MS Dos prompt) substituting the zeros in for the real IP address. If it is alive, you have a few options: 

2a. Right off the bat type "telnet 0.0.0.0" substituting the zeros for the real IP. 

2b. Get a port probe and run through the ports looking for open probes to connect to. 


3. If you choose 2a and it wont connect, try searching through the ports with a scanner looking for open ports. 

4. If you chose 2b, first try the telnet command in 2a. If it doesn't connect, look at the open ports and pick one. Open ms dos and type "telnet 0.0.0.0 113, substituting the zeros for the IP address and the 113 (in bold) for the open port you wish to connect to. 


5. If connected, and it allows annon connections, type one of the following until it works (the server commands vary): ?/help, help, /help, ?, or ?help... This will tell you all the commands in which it supports. Look through the commands an decide what to use. 

Send mail to [email protected]